pedal

If you run across a 2020 Toyota Tacoma and it has a rotational scrapping noise when the clutch is engaged, you may want to measure the crankshaft end play or remove the oil pan and retrieve the thrust washer.

We are starting to see the same low power brake pedal on the 2019-2021 Toyota Corolla's as we did on the Camry's... 2018-2021 Toyota Camry Vacuum Pump Failure and Replacement

Please see Special Service Campaign 22TC08 (Link Needed) 2022 Model Year Tundra Vehicles Engine ECU Software Update TECHNICAL INSTRUCTIONS FOR SPECIAL SERVICE CAMPAIGN 22TC08 Condition: Due to incorrect programing of the software in the engine ECU, in the event the accelerator pedal is...

Please see Recall 21TA09 Check here to see if this Recall applies to your Toyota vehicle 2018-2019 Model Year Camry Sudden Loss of Power Braking Assist May Occur On November 17, 2021, Toyota filed a Defect Information Report (DIR) with the National Highway Traffic Safety Administration...

Also please consider supporting us if you would like us to be able to help other Toyota Owners. Thanks! **** Toyota has issued a Recall on this concern. Please see this post... If you have a 2018 and up Toyota Camry (Tacoma) then you may experience a Low Braking Power message on the instrument...

Please see T-SB-0017-21 Applicability: 2021 Toyota Highlander Hybrid Introduction: Some customers may notice an abnormal brake feel in their 2021 model year Highlander Hybrid vehicle that could be described as a longer than usual brake pedal stroke. This may occur when the engine is off for...

Please see T-SB-0006-21 Applicability YEAR: 2021 Toyota Sienna Hybrid Introduction: Some customers may notice an abnormal brake feel in their 2021 model year Sienna Hybrid vehicle that could be described as a longer than usual brake pedal stroke. This may occur when the engine is off for more...

See Tech Tip T-TT-0538-19 (Sequoia) and Tech Tip T-TT-0533-19 (Tundra) CONDITION: Customers may raise a concern of a clunk type noise coming from the engine compartment shortly after start-up, due to repeated depressing of the brake pedal or shortly after the vehicle begins to move...

09 corolla. 102k when engine is fully warmed up. When stoped with your foot on the brake the idle will surge between 650 and about 450 rpm. Will only do this while foot is on brake pedal. Leave it in gear and set parking brake idle is fine. I’ve tried cleaning throttle body and throttle reset...

SUPERSESSION NOTICE: The information contained in this bulletin supersedes Service Bulletin No. T-SB-0186-12. Applicability has been updated to include 2018 and 2019 model year Tacoma vehicles. The entire bulletin has been updated. Service Bulletin No. T-SB-0186-12 is obsolete and any printed...

This TSB is Obsolete. The new TSB and Service Instructions can be found here... Some 2005 – 2017 model year Tacoma vehicles may exhibit a squeak or creak noise from the clutch pedal when it is depressed or released. Follow the Repair Procedure in bulletin T-SB-0186-12 Revision 2 to address this...

If you run across a 2008-2014 Toyota Tundra or Sequoia with a customer concern of the brake pedal goes to the floor intermittently, and the master cylinder has already been replaced, then look towards the ABS assembly as the cause. **there may not be any codes stored in the ABS ECU

If you run across a Prius that the door ajar light stays on till you press the brake pedal, then check and see if either interior work was just performed or was at a Body Shop. You will want to check connector R28 located on the drivers side C pillar by the back seat. The connector is a large...

If you run across a 3rd Gen Prius (this was a 2011) with a customer complaint of Hybrid Warning light flashes on when foot is on the brake pedal and you have codes: C2311 Communication Error from HV ECU P085D Gear Shift Control Module "A" Performance Then you will want to check and see if the...

Some 2013 – 2016 model year FR-S vehicles equipped with a manual transmission may exhibit an abnormal noise, such as a squeak, grind or groan type noise when the clutch pedal is depressed. Follow the procedure in TSB 0012-17 to address this condition. R & R Bearing Release New Part Number...

If you have a 2012-2016 Scion FRS/ Toyota 86 and are experiencing a screech type noise from the clutch pedal, then you will want to check the clutch throw out bearing as the cause.

TSB 0045-14 Revision 2 is now Obsolete. Please see the new TSB 0033-18 Some 2011-2017 Toyota Sienna vehicles may exhibit a vibration from the front brakes that can be felt in the brake pedal while lightly applying the brake pedal. New front brake pads have been developed to help improve this...

Recall Letter Owner Letter Technical Instructions Subject: Safety Recall (Special Service Campaign) – A0A Accelerator Pedal Modification Campaign Vehicles Equipped with Accelerator Pedals Manufactured by CTS Corporation 2005 – 2010 Avalon 2007 – 2010 Camry 2009 – 2010 Corolla 2010...

Recall Letter WikiPedia Article Technical Instructions for Pedal Modification (Camry) Subject: Safety Recall 90L– Remedy Available for the following Models- 2007 – 2010 Camry/Camry HV (Denso) 2007 – 2010 Camry (CTS) 2008 – 2010 Highlander HV 2004 – 2009 Prius 2008 – 2010 Highlander...