position

  1. MG

    2017-2020 Toyota 86 or 2012-2016 Scion FR-S codes P0011, P0017, P0019 and/or P0021 Used Engine Installation

    If you have the following codes (P0011, P0017, P0019 and/or P0021) after installing a used engine into one of these vehicles, then you will most likely need a new Engine ECU also. The old ECM's cannot relearn to the new engine and reprogramming on these is not possible. P0011
  2. Lewis

    2016-2018 Toyota RAV4 Hybrid with code P0A45 Drive Motor “B” Position Sensor Circuit

    Some 2016 – 2018 model year RAV4 Hybrid vehicles may exhibit a hybrid system warning message MIL ON condition with Diagnostic Trouble Code (DTC) P0A45 (Drive Motor “B” Position Sensor Circuit) present. Follow the Repair Procedure in T-SB-0079-19 bulletin to address this condition. Replace...
  3. OishiiJPN

    2016-2017 Toyota Tacoma Crankshaft Position Sensor Recall H0H

    Recall Letter You can check the status of any Recall on your Toyota here. Also read Here... Subject: Safety Recall H0H -Remedy Notice 2016 – 2017 Toyota Tacoma Crankshaft Position Sensor Recall Condition: The V6 engine crankshaft timing rotor in the involved vehicles may have been produced...
  4. Lewis

    Toyota Thermostat Installation Position Tip

    Genuine Toyota 90916-03075 Thermostat We had a Toyota vehicle towed into the shop the other day and the customers complaint was that it was overheating. The repair shop replaced almost everything in the cooling system and still had this issue so the customer wanted us to step in. We knew...
  5. MG

    What does The "B" On The Prius Shifter Mean?

    Use the B position of the Mode Selector Lever in exactly the same circumstances as you would change to a lower gear to slow down a conventional car. If you are going down a long and steep hill, controlling the car's speed using only the brakes can cause them excessive wear, get them hot and may...
Top