Please see T-SB-0022-22 Revision 1
SUPERSESSION NOTICE:
The information contained in this bulletin supersedes Service Bulletin No. T-SB-0067-20.
The Introduction, Warranty Information, Parts Information, and Required Tools & Equipment sections have been updated. The Production Change...
Please see Tech Tip T-TT-0534-19
APPLICABLE VEHICLES:
2019 RAV4 Hybrid AWD
CONDITION:
RESOLVER-R NOT ADJUSTED on MID displays all the time. This is due to MG ECU logic during production. The zero-point value for the MGR was not learned.
3 DTCs may be stored:
P1C5E19 (Drive Motor "B" Inverter...
Please see T-SB-0086-19 Revision 2
Applicability:
2019-2020 Toyota RAV4
Introduction:
Some 2019 model year RAV4 vehicles may exhibit an AWD Warning Light/Message ON condition with Diagnostic Trouble Code (DTC) C13F800 (4WD/AWD Rear Disconnect System Performance) present. Follow the Repair...
Some 2018 model year Camry vehicles equipped with four-cylinder engines may exhibit a
MIL “ON” condition with Diagnostic Trouble Code P07407E (Torque Converter Clutch
Actuator Stuck On). The Engine Control Module (ECM) (SAE term: Powertrain Control Module
[PCM]) logic has been modified to...
Subject: Warranty Enhancement Program ZH1
2013 – 2015 RAV4
Extension of Warranty Coverage for U760E Torque Converter Shudder
In our continuing efforts to ensure the best in customer satisfaction, Toyota is announcing a Warranty EnhancementProgram to extend the warranty coverage for repairs...
Please see T-SB-0023-15 Revision 2
This condition has now been covered by Toyota under a Warranty Extension called ZH1. Please read here..
Applicability:
2013-2015 Toyota RAV4
REVISION NOTICE:
March 15, 2021 Rev2:
The Production Change Information section has been updated.
August 31, 2017...
Please see T-SB-0150-16 Revision 1
Please also see this Special Service Campaign (SSC) JSD
Applicability:
2014 - 2019 Corolla
Transmission(s): CVT
REVISION NOTICE:
September 03, 2019 Rev1:
• Applicability has been updated to include 2018 – 2019 model year Corolla vehicles. Any previous...
When reinstalling a Toyota Transmission and go to put the torque converter bolts in, start with the dark colored bolt first and leave it slightly loose. Then install the rest of the lighter colored torque converter bolts and only begin to tighten them when all the torque converter have been started.
You can check the status of any LSC on your Toyota here.
Warranty Enhancement Letter ZE5
Subject: Limited Service Campaign (LSC) E03
2012-2014 Model Year Camry Vehicles Software Update for U760E Torque Converter Shudder
In Toyota's continuing efforts to ensure the best in customer...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.