If you have a 2016 Toyota Tacoma with 2GR-FKS that the customer complains about it stalling or rough idle when warm or no start after a hot soak, check the Crankshaft sensor waveform and replace if needed. Code being seen is P03352A
*** After driving the Tacoma on a few test drives after this repair, the MIL may come on with catalytic converter codes stored.
This pic shows the New sensor on the left with a circular "mark" and the old sensor installed from the factory on the right...
The location of the sensor is on the passenger side, rear of engine, just behind the oil dipstick tube. It takes its signal off a reluctor wheel near the flywheel.
*** After driving the Tacoma on a few test drives after this repair, the MIL may come on with catalytic converter codes stored.
*** After driving the Tacoma on a few test drives after this repair, the MIL may come on with catalytic converter codes stored.
This pic shows the New sensor on the left with a circular "mark" and the old sensor installed from the factory on the right...
The location of the sensor is on the passenger side, rear of engine, just behind the oil dipstick tube. It takes its signal off a reluctor wheel near the flywheel.
*** After driving the Tacoma on a few test drives after this repair, the MIL may come on with catalytic converter codes stored.