Target Placement for TSS and BSM Calibration (Park Assist Monitoring)

MG

Moderator
When used in conjunction with the Repair Manual, these Blind Spot Monitor, Forward Recognition Camera, and Front Millimeter Wave Radar tips leverage SSTs and readily available tools to support target placement in varying shop environments.

Creating the Centerline – Marking/securing the centerline of the vehicle is the first step to ensure correct target placement. A. Creating a Centerline Using a 90-degree Laser (for Blind Spot Monitor) Hint: The vehicle centerline needs to extend past the rear of the vehicle for Blind Spot Monitor procedures. 1. Hang a plumb bob from the vehicle’s front emblem, per the Repair Manual instructions, and mark the vehicle's front center point on the ground.

READ THE FULL TECH TIP HERE
 
Top